Calculator Community > General Calculator Help

BBC Basic not displaying properly on TI-84 plus

<< < (3/3)

Caleb Keatts:
Since I believe I have no hope of getting this to run on my specific calculator do you know of any other regular basic interpreters?
Thank you for your help though!

Xeda112358:
I don't know of any BASIC interpreters, but you might like Axe Parser (compiled on-calc, very fast, the syntax is rather straightforward despite the constraints).

NonstickAtom785:

--- Quote from: Caleb Keatts on November 25, 2019, 07:48:40 pm ---Since I believe I have no hope of getting this to run on my specific calculator do you know of any other regular basic interpreters?
Thank you for your help though!

--- End quote ---

Well I'm with Zeda. Axe is built to compile it's source code into assembly using TI Tokens which is very fast apposed to TI BASIC. Also I don't think Zeda will say it but his interpreter is very good (and fast) as well. I've been testing it and messing around with it for a little while. It uses BASIC Tokens and interprets/parses them using it's own system all built by Zeda. It's an app and ? is very resourceful when your trying to figure things out about it. It has constraints but everything is done mathematically and in ways it's very similar to TI BASIC, and offers - like most things for the TI calcs these days - more control over the calculator.

Here's a link to the download and any documentation you may need. Me and Zeda are working on more documentation too. So if you decide to use it and have questions post it in a Grammer forum or in the issues section on Github. Same goes for any bugs you might find.  :angel:

https://github.com/Zeda/Grammer2

Navigation

[0] Message Index

[*] Previous page