Omnimaga
Calculator Community => TI Calculators => General Calculator Help => Topic started by: Ki1o on September 09, 2012, 05:14:24 pm
-
When I tried to send a program to my calc I get an error saying that the device does not recognize the command and some numbers in brackets... what is the problem? It worked for the first three transfers. Is there a way to fix this? ???
-
What software are you using, and what program are you talking about?
-
I'm just using TI-Connect. The program I am trying to transfer is AxePaint. The first three programs I transfered are Axe, Doors CS7, and Embers:Phoenix.
-
Hmm, the obvious, but do you have enough space, did you try reattaching the wire? How about restarting the computer? Kind of obvious, but it may help.
-
I reset my entire calc, unplugged itreconnected and it seemed to work. I don't whats going on exactly with my calc. (space wasn't an issue)
-
A full wipe may help in the future, make sure to back it up too.
-
Garbage collect then ram clear.
Then try connecting to computer again.
that typically solves my problems, but TI-Connect has so many issues...
-
So essentially it's TI's fault... what's another good link pogram that I can use?
-
TiLP. :D
-
I've been meaning to ask this..is TiLP capable of sending/getting normal tns files yet? Last I checked it could only do OSes..
-
The time I tried TiLP to send tns, looked like there was some error whenever I tried to send something. So I had to completely uninstall it and go back to TI-nspire Computer Link Software.
-
I've never had any such issues, so your personal mileage may vary.
The same can be said for the TI linking softwares :P