Omnimaga

Calculator Community => TI Calculators => General Calculator Help => Topic started by: danirox on May 26, 2013, 07:46:05 am

Title: ti nspire cx cas not being charged help needed
Post by: danirox on May 26, 2013, 07:46:05 am

i got a texas nspire cx cas yesterday from an dealer in pakistan but it is not taking the charging .as soon as remove the lead it turns off .i used diagnostic test and it said the charging capacity is 100%.i am unable to caqrry it to mi tomarrow exam so please help
i am having calculas exam tomarroow so need help urgently
can send me the soolution please on my email pllease please
[email protected]

Title: Re: ti nspire cx cas not being charged help needed
Post by: danirox on May 26, 2013, 01:09:34 pm

pllease reply i need help i have mi exam tomarroow

Title: Re: ti nspire cx cas not being charged help needed
Post by: Levak on May 26, 2013, 05:35:08 pm

The initial charge is really long : ~10h through USB, ~6h using a mural charger.
Open up the diags, go to the battery check (where you saw "100%") dans pull out the cable, push it in back, then wait.
The voltage should raise during the 2 first hours.
If this doesn't work, then the only solution is to buy another battery or, if you can, return it to Texas Instruments.