Thanks a lot! I was able to get the emulator up and running My TI-Nspire is a clickpad. However, i encountered another problem... I formatted a ROM file by putting .tnc at the end (ex. Rom.gbc.tnc), but when I moved it to my calculator, it says that I am about to upgrade my calculator. I've tested this on a few roms, but they all seem to do this. Is the upgrade normal...?
Hello! I'm very new to the boards, so excuse me if my topic is in the wrong place. I recently purchased a TI-Nspire CAS, and I am trying to install Ndless onto my calculator. I updated my calculator to 2.1.0, so it should be compatible with Ndless. I used the Student Software to move two files, the 2.1.0 installation file and the resource file, into the "My Documents" folder of the calculator. When i unplugged my calculator and installed Ndless, it told me that it had successfully installed. However, I did not get any new folders from this installation, which I found odd considering all the tutorials showed an "ndless" folder with a demo inside it. Nevertheless, I also moved a Gameboy emulator into the Documents folder, but when I tried to run it, my calculator rebooted. I can only think that my Ndless did not install correctly? Or is there something else that I'm missing? Any help would be greatly appreciated
Show Posts
My TI-Nspire is a clickpad. However, i encountered another problem... I formatted a ROM file by putting .tnc at the end (ex. Rom.gbc.tnc), but when I moved it to my calculator, it says that I am about to upgrade my calculator. I've tested this on a few roms, but they all seem to do this. Is the upgrade normal...?