This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - Happybobjr
Pages: 1 ... 162 163 [164] 165 166
2446
« on: June 12, 2010, 04:48:11 pm »
working!
holy arf canoodles.
this is amazing
3 = no connection
but i can get a 2!
2447
« on: June 12, 2010, 04:34:44 pm »
finished!
now just the prog.
2448
« on: June 12, 2010, 03:43:21 pm »
nearly finished with physical part
might have it done today
2449
« on: June 12, 2010, 02:30:43 pm »
thanks... i think.... i think i understand
2450
« on: June 12, 2010, 02:24:38 pm »
i don't understand?
high and low left and right?
2451
« on: June 12, 2010, 02:12:03 pm »
hopefully.
i am doing a spring method with a pin in the center
it shakes it touches. the circuit is closed for a second.
this is where i need the code.
2452
« on: June 12, 2010, 02:06:15 pm »
chances are i'll be finished with the hardwere part of this today!
so is there any way i can have a piece of coding that checks if there is anything in the i/o
2453
« on: June 11, 2010, 09:06:11 pm »
2454
« on: June 11, 2010, 07:26:06 pm »
Interesting idea. Sadly I'm not good with my hand and hardware stuff so I would probably not attempt doing that, but it would be nice to see something like that in action 
so no one here can help?
2455
« on: June 11, 2010, 05:31:27 pm »
Do you have a cable you can salvage that can connect to the linkport? Like a phone headset?
yes i do have one that i am ready to take apart. well, I can see one way with axe. You'd need someone to make a small hex piece of asm that can check the link port connectors, since axe can't use the link port yet (i think). Sounds like a cool idea, though. I recommend, instead of metal connectors which are rather unreliable, you could have a system like those rechargeable flashlights. Shake, and the metal gives a small charge to the wire, clearing the screen. You'd have to add some sort of current limiter, probably a resistor, to prevent killing your link port.
Happy hacking!
i have no idea how to pull this off or what parts i should use. i have never attempted anything physical" before
2456
« on: June 11, 2010, 03:15:35 pm »
because it was easier for me with that name
can anyone suggest someone who could help?
2457
« on: June 11, 2010, 03:03:30 pm »
ya that is what i meant. i will remove that now.
plz help whoever can
2458
« on: June 11, 2010, 02:59:55 pm »
one compiled and one not of the etch-e-sketch that i have
2459
« on: June 11, 2010, 02:44:08 pm »
My project has just been updated to version 1.5.2 I did almost all of this while at my grandmother's house (O_O)It now contains the ability of grayscale  Up next is saving a pic for later viewing
2460
« on: June 10, 2010, 03:45:04 pm »
2.53, I take it. And that sounds bad... But then again, it's 2.53...
correct it is 2.53 thanks
Pages: 1 ... 162 163 [164] 165 166
|
|
|
Show Posts
